Astaro ASG220 ver. 8.302
Symantec 320 2.1.0(1336)
Hello,
I'm trying to create a Site to Site IPSEC VPN between these two pieces of hardware but can't quite get it to work.
I can get the tunnel to come up, both devices will show "connected" but I can only get traffic to flow from the Astaro to the Symantec. I can ping any device on the Symantec device's LAN from the Astaro LAN but not the reverse. I can't see anything in the logs of either device showing the traffic as "blocked" so I'm at a loss as to where to even look next.
My setup (on the Astaro) looks like this:
Policy
(3DES, SHA1, Group1)
Remote Gateway
(Preshared key, VPN ID Type = IP Address, Remote Network = 10.1.15.0/24)
Connection
(Local Interface = External(WAN), Policy= Symantec 320, Local Networks= 10.1.1.0/24, Auto Firewall Rules = Checked, Strict Routing = Un-Checked
Any hints or suggestions on where to look next would be greatly appreciated.
Thank you
Symantec 320 2.1.0(1336)
Hello,
I'm trying to create a Site to Site IPSEC VPN between these two pieces of hardware but can't quite get it to work.
I can get the tunnel to come up, both devices will show "connected" but I can only get traffic to flow from the Astaro to the Symantec. I can ping any device on the Symantec device's LAN from the Astaro LAN but not the reverse. I can't see anything in the logs of either device showing the traffic as "blocked" so I'm at a loss as to where to even look next.
My setup (on the Astaro) looks like this:
Policy
(3DES, SHA1, Group1)
Remote Gateway
(Preshared key, VPN ID Type = IP Address, Remote Network = 10.1.15.0/24)
Connection
(Local Interface = External(WAN), Policy= Symantec 320, Local Networks= 10.1.1.0/24, Auto Firewall Rules = Checked, Strict Routing = Un-Checked
Any hints or suggestions on where to look next would be greatly appreciated.
Thank you