Dear all
I am facing an issue with Astaro ver 8.305. Most probably is an ISP issue but i would really appreciate it if you can point me to a solution.
I have the external interface on my Astaro as Cable DHCP. It always take the same public IP address which is for example 212.x.x.5 It also takes a gateway from the ISP DHCP 212.x.x.1.
I have a block of 8 additional IP in the range of 91.x.x.16/29. Those ip adresses are set up as additional adresses on external interface (Cable DHCP). DNAT works fine on those adresses. The problem is the when i SNAT a port lets say 25 in order to present one of the 91.x.x.x adresses to the outside world i can not reach anything. The provider said me that 91.x.x.17 is the gateway for the subnet of aditional adresses but how i am supposed to utilize this since those adresses as just set as additional on the Cable DHCPInterface
Any ideas??
I am facing an issue with Astaro ver 8.305. Most probably is an ISP issue but i would really appreciate it if you can point me to a solution.
I have the external interface on my Astaro as Cable DHCP. It always take the same public IP address which is for example 212.x.x.5 It also takes a gateway from the ISP DHCP 212.x.x.1.
I have a block of 8 additional IP in the range of 91.x.x.16/29. Those ip adresses are set up as additional adresses on external interface (Cable DHCP). DNAT works fine on those adresses. The problem is the when i SNAT a port lets say 25 in order to present one of the 91.x.x.x adresses to the outside world i can not reach anything. The provider said me that 91.x.x.17 is the gateway for the subnet of aditional adresses but how i am supposed to utilize this since those adresses as just set as additional on the Cable DHCPInterface
Any ideas??