Has anyone been able to see their wireless network on an iPhone 4 (iOS 5.1.1) when broadcasting on 5GHz? I can only see mine and connect when using 2.4GHz using an AP10. I was wondering if there was a compatability issue with iPhone 4's or if there was a problem with my AP, i'll try another phone later in case there is a problem with this one.
Interestingly from the wireless log i see this message Interface type not supported can anyone tell me what this means?
sysinit: rm: can't remove '/var/run/hostapd-*.maclist':No such file or directory
kernel: [ 275.110000] RED: red_tunnel_release: freeing tunnel 800
sysinit: 192.168.2.100 = 192.168.2.100
kernel: [ 275.160000] RED: tunnel id 800, use_crypto was set to 0
kernel: [ 275.490000] device eth0 entered promiscuous mode
kernel: [ 275.490000] br-lan: port 1(eth0) entering forwarding state
kernel: [ 275.490000] br-lan: port 1(eth0) entering forwarding state
sysinit: Interface type not supported.
2012:07:06-17:26:29 192.168.2.30 kernel: [ 276.080000] cfg80211: Calling CRDA for country: GB
sysinit: Usage: iw [options] phy <phyname> set antenna <bitmap> | all | <tx bitmap> <rx bitmap>
Interestingly from the wireless log i see this message Interface type not supported can anyone tell me what this means?
sysinit: rm: can't remove '/var/run/hostapd-*.maclist':No such file or directory
kernel: [ 275.110000] RED: red_tunnel_release: freeing tunnel 800
sysinit: 192.168.2.100 = 192.168.2.100
kernel: [ 275.160000] RED: tunnel id 800, use_crypto was set to 0
kernel: [ 275.490000] device eth0 entered promiscuous mode
kernel: [ 275.490000] br-lan: port 1(eth0) entering forwarding state
kernel: [ 275.490000] br-lan: port 1(eth0) entering forwarding state
sysinit: Interface type not supported.
2012:07:06-17:26:29 192.168.2.30 kernel: [ 276.080000] cfg80211: Calling CRDA for country: GB
sysinit: Usage: iw [options] phy <phyname> set antenna <bitmap> | all | <tx bitmap> <rx bitmap>