After instlling ver 8 (latest iso), my box will not boot up. I tried to reinstall ver 7 and I receive an "Info box" declaring an unknown error when I attempt to upload the initial info (host, location, passwords, & email.
Ver 7 was working fine before this upgrade attempt.
I did have to replace a power supply on the box, but otherwise I have not found any obvious hardware problems. I'm checking the HD with spinrite as I write this. I'm looking for any bad areas.
I have never had a problem before with any ASG installation before.
I did notice that at the end of the the v8 install, there were two "failed" commands. I believe one said Start... I should have written them down. When spirite finishes, I'll get them.
Any ideas as to why,
1) v8 doesn't start / boot up after the install
2) v7 doesn't accept the initial data on the eula agreement page.
Thanks.
Ver 7 was working fine before this upgrade attempt.
I did have to replace a power supply on the box, but otherwise I have not found any obvious hardware problems. I'm checking the HD with spinrite as I write this. I'm looking for any bad areas.
I have never had a problem before with any ASG installation before.
I did notice that at the end of the the v8 install, there were two "failed" commands. I believe one said Start... I should have written them down. When spirite finishes, I'll get them.
Any ideas as to why,
1) v8 doesn't start / boot up after the install
2) v7 doesn't accept the initial data on the eula agreement page.
Thanks.