Hi all, first off let me say this is my first time with this firewall. I usually use screenOS, JUNOS or ASA's. I'm switching my ASA out with this firewall for my home network.
My issues, My cable modem will not connect, I did the samething I did to get it to connect to my ASA which was power cycle and set the ASA to dhcp and it worked. With this firewall, it just shows link up and state down.
Also, I ran a crossover cable from the inside interface to my switch and the Astaro wouldn't recognize my crossover cable but did recognize it when I plugged the cat 5 cable back into the switch.
3rd but least of my major concerns, I configured an interface for wireless security and I have my linksys connected to that port and its in the same state as the cable modem, link up and state down.
Any help, suggestions or point me in the direction of some literature or a KB on this would be most helpful.
My issues, My cable modem will not connect, I did the samething I did to get it to connect to my ASA which was power cycle and set the ASA to dhcp and it worked. With this firewall, it just shows link up and state down.
Also, I ran a crossover cable from the inside interface to my switch and the Astaro wouldn't recognize my crossover cable but did recognize it when I plugged the cat 5 cable back into the switch.
3rd but least of my major concerns, I configured an interface for wireless security and I have my linksys connected to that port and its in the same state as the cable modem, link up and state down.
Any help, suggestions or point me in the direction of some literature or a KB on this would be most helpful.