I have rebuilt this UTM 3 times now to try and get past the hanging when I change the external interface to ADSL PPPoE with IPv6 enabled.
The AP10 connects for a short while then the power light just keeps flashing. I cannot ping the interface or even get an IP address from the DHCP server.
I would post logs if I could get into the box, but I can't. From testing though, it would appear as though the interface hangs causing the UTM to hang. Top shows lots of activity. At one stage I saw a message on the console about interrupt 16 being disabled. Also I get a message about the hotspot which I didn't get on this UTM.
Ian
Ian
The AP10 connects for a short while then the power light just keeps flashing. I cannot ping the interface or even get an IP address from the DHCP server.
I would post logs if I could get into the box, but I can't. From testing though, it would appear as though the interface hangs causing the UTM to hang. Top shows lots of activity. At one stage I saw a message on the console about interrupt 16 being disabled. Also I get a message about the hotspot which I didn't get on this UTM.
Ian
Ian