Something which I am finding odd with the UTM software application on my micro ATX box is that if I have to change ATT Uverse routers, I have to completely redo the installation of my UTM to get it to work. I've tried restoring from a backup even and it won't do. I have to actually physically wipe the box and start from scratch.
When I moved from TX to KS, keeping the same service, but getting a new UVerse router, I could not get the UTM to work. Once I reloaded the system completely, it worked flawless. Now, I had to change out my UVerse router because it died. I got my new one today, and my UTM was working great. I set up my UVerse router the exact same configuration, then hooked up the UTM - doesn't work. Restoring from a backup doesn't work either after a factory reset. Tomorrow when I get home from work, I will reload this thing yet again from scratch, set it up the exact same way, and it will work.
When I moved from TX to KS, keeping the same service, but getting a new UVerse router, I could not get the UTM to work. Once I reloaded the system completely, it worked flawless. Now, I had to change out my UVerse router because it died. I got my new one today, and my UTM was working great. I set up my UVerse router the exact same configuration, then hooked up the UTM - doesn't work. Restoring from a backup doesn't work either after a factory reset. Tomorrow when I get home from work, I will reload this thing yet again from scratch, set it up the exact same way, and it will work.
