Zte mg628

Gents,

i'm trying to get a ZTE MF628 working in UTM9.

With the commmand lsusb i get the following output:

DJICTVEN00F001:/home/login # lsusb
Bus 001 Device 003: ID 03f0:1024 Hewlett-Packard Smart Card Keyboard
Bus 003 Device 003: ID 19d2:0015 ONDA Communication S.p.A.
Bus 001 Device 001: ID 1d6b:0001 Linux Foundation 1.1 root hub
Bus 002 Device 001: ID 1d6b:0001 Linux Foundation 1.1 root hub
Bus 003 Device 001: ID 1d6b:0001 Linux Foundation 1.1 root hub
Bus 004 Device 001: ID 1d6b:0001 Linux Foundation 1.1 root hub
Bus 005 Device 001: ID 1d6b:0002 Linux Foundation 2.0 root hub
DJICTVEN00F001:/home/login #

And with dmesg | grep usb:

[ 4.576020] usb 3-1: new full-speed USB device number 3 using uhci_hcd
[ 4.744075] usb 3-1: New USB device found, idVendor=19d2, idProduct=0015
[ 4.744232] usb 3-1: New USB device strings: Mfr=1, Product=2, SerialNumber=3
[ 4.744378] usb 3-1: Product: ZTE CDMA Technologies MSM
[ 4.744523] usb 3-1: Manufacturer: Qualcomm, Incorporated
[ 4.744668] usb 3-1: SerialNumber: Data Interface
[ 4.747311] scsi3 : usb-storage 3-1:1.0
[ 4.750393] usb 3-1: GSM modem (1-port) converter now attached to ttyUSB0
[ 4.752380] usb 3-1: GSM modem (1-port) converter now attached to ttyUSB1
[ 4.754376] usb 3-1: GSM modem (1-port) converter now attached to ttyUSB2
DJICTVEN00F001:/home/login #

So my UTM9 sees the modem, but i don't see him as an interface...
And my UTM9 sees the internal flash during the installation of UTM9, it's a clean install btw.

Has someone some ideas for getting this working..??

My UTM9 is a soft-appliance.

Kinds regards