Morning,
Yesterday evening I installed the UTM 9 beta on my home ESXi system to test the new features (some of which I need for work when this goes GA) and ran across a strange issue.
Under ASGv8 - 8.3, I have several VLAN interfaces on eth3. They're in place so I can run several isolated WiFi networks off my Engenius EAP-9550. Everything works fine under 8.3.
When I installed the beta, the config I imported from 8.3 appeared to work just fine. All the settings, firewall rules, interface configs, etc appeared to transfer over just fine. When I came back upstairs, my wife mentioned her laptop wasn't working. Checked it out and the unit sees my WiFi but doesn't get an IP address from the UTM's dhcp server.
This morning I switched back to the 8.3 vm and everything comes back up fine. Swap back to the beta and it stops working again.
I've attached the logs of the tcpdump I ran while running some tests. 10.0.200.67 is the laptop's dhcp assigned IP. The 169.254.112.25 is it's fallback when Windows 7 can't identify the network. The gateway for that network is 10.0.200.65. In both configs, non-VLAN interfaces work just fine.
There are two text files in the zip. the .v9.txt is from the beta and the .v8.txt is from the (working) 8.3 install. I've also attached config.txt which shows my firewall's routes & interface configs.
Yesterday evening I installed the UTM 9 beta on my home ESXi system to test the new features (some of which I need for work when this goes GA) and ran across a strange issue.
Under ASGv8 - 8.3, I have several VLAN interfaces on eth3. They're in place so I can run several isolated WiFi networks off my Engenius EAP-9550. Everything works fine under 8.3.
When I installed the beta, the config I imported from 8.3 appeared to work just fine. All the settings, firewall rules, interface configs, etc appeared to transfer over just fine. When I came back upstairs, my wife mentioned her laptop wasn't working. Checked it out and the unit sees my WiFi but doesn't get an IP address from the UTM's dhcp server.
This morning I switched back to the 8.3 vm and everything comes back up fine. Swap back to the beta and it stops working again.
I've attached the logs of the tcpdump I ran while running some tests. 10.0.200.67 is the laptop's dhcp assigned IP. The 169.254.112.25 is it's fallback when Windows 7 can't identify the network. The gateway for that network is 10.0.200.65. In both configs, non-VLAN interfaces work just fine.
There are two text files in the zip. the .v9.txt is from the beta and the .v8.txt is from the (working) 8.3 install. I've also attached config.txt which shows my firewall's routes & interface configs.