[9.004] RED50 behavior

Hi,

1. is this correct: when the device says restarting, it only tries to restart the tunnel?

2. When I diconnected WAN2, only a few pings get lost.

When I disconnected WAN1, first only a few ping get lost, then everythin is OK, then RED50 says restarting, pings are OK, then it tries to connect WAN1 (still not connected), a few pings get lost, then WAN2 shows active in LCD display. But it seems to be a few to much lost packets.

3. When I connect WLAN1 again, it still says connected to WAN2, ist this correct?

Sven