Maybe somebody can help me?
Have 2 ASG V8, on both two uplink interface, eth 0 on both ASG in same provider network and that is a problem!
When first interface (eth0) down on ASG1 bat eth0 on ASG2 dont wall ASG1 use eth1, bat route table say ASG1 89.105.145.86(ASG2 IP) you wind on 89.105.145.66 (eth0). Soooooo bad, have some ideas about that?
If Im disable eth0 on ASG1 all is fine.
:confused:
Have 2 ASG V8, on both two uplink interface, eth 0 on both ASG in same provider network and that is a problem!
When first interface (eth0) down on ASG1 bat eth0 on ASG2 dont wall ASG1 use eth1, bat route table say ASG1 89.105.145.86(ASG2 IP) you wind on 89.105.145.66 (eth0). Soooooo bad, have some ideas about that?
If Im disable eth0 on ASG1 all is fine.
:confused: